Cleaning Poultry Breeder Houses
By: Hosam Amro, Senior Manager Technical Service, Cobb Europe LTD
The first step of any disease prevention program starts with a comprehensive plan for cleaning. This plan is multifaceted and includes a rigid set of principles, good husbandry and management practices as well as a clear employee understanding of the importance of the cleaning process. The purpose of cleaning is to reduce or kill biosecurity threats to the health of future flocks. This includes vermin, rodents, insects, bacteria, viruses and parasites. Cleaning a poultry house is similar to peeling an onion in that it must be done in layers. First there is the physical removal of debris such as dirt, dust and litter using equipment such as tractors, blowers and brooms. Second, is the reduction or elimination of debris adhered to surfaces and in difficult to reach places. Finally apply water and detergent to free any remaining material adhering to the equipment
Preparation and Pre-cleaning
- Ensure that the house is completely empty before cleaning.
- Insects (flies, mites, ticks, beetles and cockroaches) carry and spread diseases. An effective insect eradication and control program is most effective once the house is empty but still warm. Spray an approved insecticide both inside and outside the building (including a 6 m wide area around the house). The outside application is important because insects will look for places to hide and hibernate as the building cools making eradication more difficult. The building should be closed for three to four days after insecticide treatment.
- After house depopulation, use bait stations and rodenticide that cause death after a single dose. All feed should be removed from feeders to attract rodents to the bait stations. Bait stations should be placed inside and outside the poultry houses.
- Collect and remove litter from the flock in sealed trucks. Bury or burn the litter if the previous flock has experienced a disease outbreak.
- Perform maintenance and repair of surfaces including floor cracks, door frames, damaged panels, slats and equipment.
- All cleaning operations should begin with the uppermost surfaces and proceed downwards to minimize possible re-contamination of previously cleaned areas.
- Dismantle all removable equipment, slats and fittings, remove them from the building and collect them in a specific area outside the poultry house for cleaning.
- Dry cleaning (i.e. brushing, scraping, vacuum cleaners, air blowers etc.) should be performed inside and outside the poultry house, farm storage, and egg rooms. While dry cleaning, pay special attention to the fans and air inlets, light system, beams (especially in corners) heating system and electrical equipment which cannot be removed (e.g. motors, switches). These difficult areas should be dry cleaned by blowing with compressed air. Egg collection equipment should be opened and egg belts removed. All egg debris, dust and dirt should be swept away.
- Wet cleaning involves washing and possibly soaking the poultry house with water and detergents using a high-pressure washer. The water quality has to be minimally fit for animal consumption, and free of organic or inorganic material that may negatively interfere with chemical efficacy. Use warm water (60°C, 140° F) for all wet cleaning steps.
- Electrical equipment including control panels and switches should be waterproof or covered with plastic sheets and tape. An International Protection Code (IP) of IP65 or higher is required for the lighting system to withstand high pressure washing procedures. High pressure spraying will facilitate the washing of hard to reach areas. Correct washing should be done systematically, starting from the top downwards and from the back of the house to the front moving carefully from one side of the house to the other side. All surfaces must be completely cleaned, including ceilings, walls, feeding and watering systems, egg nests, and conveyors. If a lot of water or dirt is collected on the floor, remove it to avoid recontamination of previously cleaned areas.
- Some of the equipment may require soaking to loosen dirt, but all of them should be staged above the floor with sufficient drying space.
- Other rooms and farm facilities such as farm storage rooms, egg rooms, and personal facilities like canteens, showers and restrooms should be carefully washed with high pressure.
- Water systems should be flushed with high pressure 15 to 30 psi, then filled with water sanitizer used in accordance with the manufacturer’s recommendation. Allow sanitizer to remain in the system for 24 hours. It then needs to be flushed again with high pressure until the water coming out from the system is clear.
- Silos must be completely emptied and cleaned from above by high-pressure washing, both inside and outside. Feed taken from a silo must not be used for subsequent flocks.
Under practical farming conditions site sterilization is impossible, but every possible measure which helps to reduce the risk of infection is worthwhile. Integrating a well-planned cleaning and disinfection program with sound biosecurity makes it more likely obtain successful breeder production results. Thorough cleaning and disinfection between flocks is the first step towards meeting animal welfare regulations, achieving the breed’s genetic potential and optimizing revenue according to the farm potential.
Remove litter from house as part of the pre-cleaning and preparation step
Photo Source: Cobb-Vantress
Use high pressure washing to remove soil and dirt working from the top of the house to the floors.
Photo Source: Cobb-Vantress